2020年5月24日 · Needs a wire ran to the torch, making a simple gas cooled torch lead setup more complicated. While well built, it could be a bit more industrial. Sensors and connectors might get damaged at busy job sites. No sensitivity adjustment. Included wire is not heat-resistant, and I'm not following the directions by using it without a sleeve.

2020年2月22日 · I was on-line and found the "TIG BUTTON". I've never looked back or use any other control for my Syncrowave. I leave the button just loose enough on my torch handle that I can roll it left to right depending on my need with right hand or left hand. You will also get great service from this company. Dave has treated me more than fair!

2006年6月12日 · You would want a mid length cap for 3-1/2" tungsten and a button cap for shorter and to get into tight places. With a long cap you can use a 7" tungsten without cutting it to make it shorter. I tend to use a mid length most of the time and cut tungstens in half and sharpen both ends right away when I get a new box of ten.

2011年5月21日 · Some TIG machines have a small switch on the torch (in place of a pedal) that turns on the arc using a preset heat on the machine.....what is the specific name for this? Last edited by rahtreelimbs ; 05-22-2011, 04:24 PM .

2020年3月9日 · Assuming you are only going to use the front panel settings for current and only want an on/off button on the torch (not the easiest way to tig weld), you just connect your switch between pins 4 and 6 on the 15-pin connector. If you want to control current, you will need 5 wires and a variable resistor as well as a switch on the torch.

2010年1月23日 · Ok I just did the jumper thing between A and B. Nothing happened. I had it on AC and then I turned the power off, changed to polarity to DCEN, turned the power on and saw no change. I pushed the function select button a few times toggeling between TIG and Stick. The light for the "ON" never came on when I was on TIG.

2009年2月10日 · 2. The rotary encoder mounted on the TIG torch would be an industrial grade precision encoder with a resolution of 64 steps per revolution. Very smooth to turn, high precision, good feel and feedback through the knob. 3. You would "push" the rotary encoder knob (push perpendicular to the rotating direction) to start and stop the torch.

2009年6月24日 · CK Worldwide makes a nice torch with a built in hand control. You can choose between north/south slider or one that rotates. I have the CK-20 water cooled one, though I use it with a foot pedal cause I just couldn't operate the finger control without wiggling the torch. Not the torch's fault, my fingers just don't operate that way.

2004年1月16日 · It is a very tight spot, but I am going to TIG with a flat back cap and a rigid head Miller Diamond back # 17. I like it a little better than the Weldcraft due to it's angled head rather than a 90 degree head. Just preference. I would have 50' torch leads if they were easily available.

2013年9月21日 · CK FlexLoc Tig torch query. 09-21-2013, 06:49 PM I've seen the videos of CK's range of FlexLoc torches with the 360 degree rotating heads and they interest me quite a bit.