2018年3月15日 · Ronin's Grips - Polymer80 Pistol Frame M35 Drill Bits 3mm & 4 mm - These quality drill bits are sized for drilling Polymer80 pistol frames for their pins. This package includes one 3mm drill bit (approx. 2.95-2.97mm) and one 4mm drill bit (approx. 3.95-3.96mm).

2017年11月28日 · Any carbide tool is harder than Tenifered steel. A solid carbide drill bit would drill a Glock barrel easy. And heat build up is a good point. You don't know if you can leave a shoulder until you start really looking into drill sizes, interior dimensions, cost, blah blah blah. Soft solder (or silver) would do it though. Cat

2025年1月16日 · Drill or Drill Press 4-40 X 1/2" Set Screws (0.65 each at the local hardware store as of this post) 4-40 Tap & Tap Handle (can be found along with drill bit under $10 online as of this post) #43 Drill Bit Oil/Cutting Fluid

2011年9月14日 · This is the hard part. The trigger bar is VERY hard to drill through. You will use the same 5/64" drill bit here, but expect to use up several. I used a DeWalt titanium split tip (2 actually), and Rigid cobalt bits. Once you get through the outer coating, the bit will cut right through. 4. Trim the bar.

2024年12月7日 · It has that drill bit / Phillips screwdriver head and I think it's called the extreme defender because I don't think that 38 will expand out of a JFrame barrel so it's better than a hollow point or wad cutter. There are many better options in my honest opinion in 9 mm that have been proven and actually cost quite a bit less.

2020年3月19日 · So I went to Lowe's and bought the Irwin 8 - 32 tap and drill bit set. Along with that I bought several $4 to $5 Dewalt drill bits 3/32 7/64 and 9/64. These were labeled as Dewalt Split Point, very sharp. And 2 of the 8-32 set screws with the Allen head, these were roughly 3/8 inch long. I never used the 9/64 bit in this build or repair.

2024年12月30日 · The shorter slide and barrel of the G45 can make it more comfortable while seated, as you discovered, but that’s about the only benefit from a carry perspective. The G45 has a bit more felt recoil, but the sights return to target quickly. The differences in …

2016年10月27日 · So I went to Lowe's and bought the Irwin 8 - 32 tap and drill bit set. Along with that I bought several $4 to $5 Dewalt drill bits 3/32 7/64 and 9/64. These were labeled as Dewalt Split Point, very sharp. And 2 of the 8-32 set screws with the Allen head, these were roughly 3/8 inch long. I never used the 9/64 bit in this build or repair.

2024年11月8日 · Occasionally I carry my G26 in a RM Lowrider IWB holster and use a Kore Essentials ratcheting belt. Tighten belt when standing or walking or loosen just a bit when sitting. However, I do admit the P365 has spoiled me on IWB carry.

2013年2月16日 · I just did this. Only variation: drilled small pilot hole in center, then used a larger (just a little smaller than the diameter of the nut) bit, and carefully drilled down, and just sheared off the whole bolt head. Then just tapped out the old sight.